Researchers from the University of Science and Technology of China (USTC) designed a simple method to produce copper-based nanomaterials that would be applied to semiconductor material systems for better performance.
Copper-based quaternary sulphide nanomaterials, for example, Cu-Zn-In-S (CZIS) and Cu-Zn-Ga-S (CZGS), consists of non-toxic elements are attractive candidates for solar photocatalytic hydrogen production. This is attributed to their tunable bandgap, good chemical and thermal stability, environmental benignity, and facile synthesis from abundant and inexpensive starting materials. Unfortunately, the low electric conductivity, rapid recombination rate of photogenerated electrons and holes as well as the less accessible surface-active sites have greatly limited their photocatalytic performance.
A research group led by Professor Yu Shuhong at the University of Science and Technology of China have designed a simple colloidal method to synthesize single crystalline wurtzite CZIS nanobelts, as well as the single crystalline wurtzite CZGS nanobelts assisted with oleylamine and 1-dodecanethiol. The research article entitled “Single crystalline quaternary sulphide nanobelts for efficient solar-to-hydrogen conversion”, was published in Nature Communications.
Researchers first used first principle density functional theory (DFT) calculation to explore the reaction Gibbs energy (ΔGH) at the (0001), (1010), and (1011) facets of wurtzite CZIS. The calculation results showed that the (0001) facet had the smallest binding strength to atomic hydrogen. Following the Bell-Evans-Polanyi principle, researchers expected that the (0001) facet was the most favourable surface for photocatalytic hydrogen production on CZIS.
Researchers then designed a simple colloidal method to synthesize single crystalline wurtzite CZIS nanobelts exposing the (0001) facet, as well as the single crystalline wurtzite CZGS nanobelts with the exposed (0001) facet assisted with oleylamine and 1-dodecanethiol. The prepared nanobelt photocatalysts demonstrated excellent composition-dependent photocatalytic performances, for CZIS and CZGS nanobelts under visible-light irradiation (∆>420 nm) without a co-catalyst.
This work shows the significance of surface engineering of quaternary sulphide photocatalyst to achieve better performance. This photocatalyst design method can be exploited to other semiconductor material systems, thereby enabling novel photocatalysts that use the low-cost elements to efficiently catalyse special reactions. [APBN]